EN - FR
 
  Acceuil | Présentation | Produits | Photos | Nouvelles | Technique | Implantation | Contact
 

PTFE Detailed Properties
(Polytetrafluoroethylene)

The table below lists a generally accepted summary of properties that we believe to be reliable. Please note that many of these resins are produced in several varieties and property characteristics may vary. Therefore, determination of resin is dependent on the application and this table is only meant to serve as a general guideline.

Properties ASTM or Unit PTFE
MECHANICAL PROPERTIES
Specific Gravity D792 2.18
Elongation % D638 200~450
Tensile Strength (psi) D638 2,000~7,000
Flexural Strength (psi) D790 no break
Compressive Strength D695 3,500
Tensile Elastic Modulus
(Young's Modulus) (psi)
D638 57,000
(psi)
Flexural Modulus
103MPa (103kgf/cm2)
D790 71,000~
85,000
D790 0.5-0.6
(5.0-6.0)
FlexLife
(MIT cycles)
D2176 >1,000,000
Hardness Durometer
Shore D
D636 D50~65
Coefficient of Friction on steel 0.02
Abrasion Resistance
1000 revs.
Taber 12
Impact Strength IZOD
73°F/23°C, notched ft/lbs/in
D256 3
THERMAL PROPERTIES
Melting Point °C
(°F)
327
(621)
Upper Service
Temperature(20,000h)
°C
(°F)
260
(500)
Flame Rating** UL 94 V-0

Thermal Conductivity

BTU/hr/ft2/deg F in 1.7
cal/sec/cm2,ºC/cm 6 x 10-4
Linear Coefficient of Thermal Expansion 10-5 °C D696 >11.6
Heat of Fusion BTU/LB 29-37
Heat of Combustion BTU/LB 2200
Low Temperature Embrittlement °C
(°F)
-268
(-450)
ELECTRICAL PROPERTIES
Dielectric Constant D150/103Hz 2.1
D150/106Hz 2.1
Dielectric Strength
10 mil film
D149 >1400
Volume Resistivity ohm-cm D257 >1018
Surface Resistivity
ohm/sq.
D257 >1017
GENERAL PROPERTIES
Chemical/Solvent
Resistance
D543 Excellent
Water Absorption, 24h % <0.01
Deformation Under Load *D621/100°C 5.0
**D621/25°C 7.0
Refractive Index   1.35
Limiting Oxygen Index >95 >95
Properties ASTM or Unit PTFE
*6.8 MPa (986 psi),24h
**13.7 MPa (1987 psi),24h

< Back

Xtraflex NV - paaiestraat 13 - 2500 Lier TEL +32 (0)3 680 11 90 - FAX +32 (0)3 680 11 99